ACCURATE BIN AND TRUCK SAMPLING
Very few fields of grain in Montana are totally level or uniform in quality. Lower areas have more subsoil moisture, higher bushel per acre yields and lower protein. Higher areas have less moisture, fewer bushels per acre and higher protein. Frost settles in low areas in a field resulting in non-uniform percentages of frost damage. Moisture creates higher percentages of sprout damage on the portion of a field that is the most mature. These conditions result in very few bins being totally uniform in quality.
It is extremely difficult to accurately sample a bin after it has been filled. Sampling a full bin with a sectioned or standard tier probe leaves large areas of the bin unsampled. This results in grade, dockage and/or protein results that often do not match results on delivered grain.
It is in the producer's and the elevator's best interest to negotiate grain sales based on accurate bin sample results. Producers and elevators both dislike the problems resulting from a difference in bin sample and unload results.
The most accurate way to sample a truck is with a compartmentized tier probe. Realizing this is impractical during harvest or in most elevator settings, following are some practical suggestions for accurately sampling a bin or truck.
- Pre-harvest planning, a five-gallon plastic bucket numbered
for each bin or composite sample and a sampling device.
- Use a standard sampling device; a coffee can or metal coffee
cup, etc.
- Sample each truck load according to size so the sample will
represent the bin or lot of grain.
- A cut of the stream for every 100 bushels. Example: A 300-bushel
truck three cuts, a 500-bushel truck five cuts or a 1,000 bushel truck
10 cuts. This will weight the sample by
volume to represent the bin or lot of grain.
- The sampling device should be quickly drawn across the
stream of grain from one side to the other without
completely filling the device.
- As protein and quality can vary considerably in a bin or lot
of grain, the sample should be thoroughly mixed.
- Hand mixing of a bin or composite sample does not achieve
consistent accurate results. The most efficient way of
mixing a sample is to utilize a divider/mixer. As most
producers or elevators do not have access to a
divider/mixer, the following methods work well.
- Place the bin sample on a tarp and thoroughly mix with
a garden hoe.
- Pour the elevator composite sample from one container
to another, approximately 10 times.
- Place the bin sample on a tarp and thoroughly mix with
a garden hoe.
SUGGESTIONS FOR SAMPLING BINS
To sample bins that are full use one of the following two methods.
- SECTION PROBE
Probe grain at the inspection cover and if possible at the center of the bin adding sections until the probe has been pushed into the grain as far as possible or the bottom of the bin is reached. If it is only possible to sample at the inspection cover probe in different directions to acquire grain from different locations in the bin.
- TIER PROBE
Probe grain at the inspection cover and if possible at the center of the bin. Also take one probe through the augur hole to draw a portion of the sample from the bottom of the bin. If it is only possible to sample at the inspection cover probe in different directions to acquire grain from different locations in the bin.
Hand mixing of a bin sample does not achieve consistent accurate results. The most efficient way to mix a sample is to use a divider/mixer. As most producers do not have access to a divider/mixer the following methods work well.
- Place the bin sample on a tarp and thoroughly mix with a
garden hoe.
- Pour the bin sample from one container to another at least ten times.
- Place the bin sample on a tarp and thoroughly mix with a
garden hoe.
